PRIVATE DESIGN PREVIEW Product data and supply terms are being verified. RFQ lists stay in this browser.
Wenzhou Changsong Electric Co., Ltd.
Catalogs & technical filesContact & inquiryEN
CHSOINDUSTRIAL ELECTRICALRequest a quote 0→

How to Select Copper Busbars for Low-Voltage Distribution Panels

· admin

Copper busbars look simple on a quotation sheet. A width, a thickness and a quantity can make the item seem easy to buy. In practice, many ordering problems start because the buyer and supplier are using different assumptions about current, hole positions, bending, insulation or the way the busbar will be installed.

This guide is written for panel builders, importers and electrical distributors who need to confirm a copper busbar specification before asking for a quotation.

Start with the application

First describe where the busbar will be used. A main distribution board, a control panel, a switchgear assembly and a battery cabinet may use different layouts even when the copper grade is similar. Tell the supplier whether the part is a straight bar, a drilled bar, a bent connection, a flexible link or a complete busbar assembly.

The basic dimensions

The usual starting points are width, thickness and overall length. Add the hole diameter, hole spacing, edge distance and any slots. A drawing is the safest way to remove doubt. If there is no drawing, mark the dimensions on a clear photograph or provide a simple sketch.

Do not send only the required current. Current capacity depends on the conductor size, the arrangement, the surrounding temperature, ventilation and the permitted temperature rise. The supplier can use the current as a reference, but the final size should be checked against the actual installation.

Bare copper or tinned copper

Bare copper is common in indoor assemblies where the environment is controlled. Tinned copper can be useful where the busbar may face humidity, oxidation or repeated connection and disconnection. The right choice depends on the contact system and the environment. It should be confirmed with the equipment designer rather than selected only because one finish looks more attractive.

Machining and forming details

Many busbars need more than cutting. The order may include drilling, countersinking, bending, edge rounding, threading, insulation or heat-shrink covering. These details affect both price and fit. State which surfaces must remain flat and which areas must be free from burrs.

For a bent busbar, provide the bend direction, inside radius, reference face and the distance from the bend to each hole. A sample part can also help when the drawing is not complete.

What to include in an inquiry

  • Material and finish
  • Width, thickness and total length
  • Hole diameter, spacing and pattern
  • Bend angle, radius and direction
  • Insulation or protective covering
  • Quantity for samples and production
  • Packaging and labeling requirements
  • Target delivery location

Common purchasing mistakes

The most common mistakes are using a current rating without describing the installation, sending an old drawing, forgetting the hole reference, and treating a similar-looking part as interchangeable. Another frequent issue is approving a sample without checking it in the actual enclosure.

Before production starts

Ask for a drawing or marked confirmation that repeats the agreed dimensions. Check the sample against the enclosure, terminal position and fixing hardware. Once the specification is clear, the quotation becomes easier to compare and the risk of rework is lower.

If you are sourcing a custom copper busbar, send the drawing, dimensions, quantity and finish requirements with your inquiry. CHSO can review the information and confirm which details are needed before quotation.

Leave a Reply

Your email address will not be published. Required fields are marked *